Honda CR-V manuals

Honda CR-V: Accessory Power Sockets

Honda CR-V (2006–2011) Owner's Manual / Instruments and Controls / Interior Convenience Items / Accessory Power Sockets

Your vehicle has two or three

Your vehicle has two or three accessory power sockets depending on the model.

To use an accessory power socket,

To use an accessory power socket, the ignition switch must be in the ACCESSORY (I) or ON (II) position.

Each socket is intended to supply power for 12 volt DC accessories that are rated 120 watts or less (10 amps).

None of the sockets will power an

None of the sockets will power an automotive type cigarette lighter element.

Make sure to put the socket cover

Make sure to put the socket cover back in place to prevent any small foreign objects from getting into the socket.

READ NEXT:

 Console Compartment

EX-L model Push the release knob to open or close the console compartment, slide the lid rearward.

 Coat Hook

To use a coat hook, slide it out slightly, then pull it down. Make sure the coat hook is folded up when you are not using it. This hook is not designed for large or heavy items.

 Seat Under Tray

If equipped Your vehicle has a seat under tray located under the front passenger seat. Use the tray by pulling on the front center edge of the tray.

SEE MORE:

 Symptom Troubleshooting

Low pressure indicator does not come on, and no DTCs are stored 1. Turn the ignition switch ON (II). 2. Check the low pressure indicator for several seconds when the ignition switch is turned ON (II). Did the indicator come on and then go off? YES-Go to step 3. NO-Go to step 8. 3. Turn the ignit

 Connectors and Harnesses

Connector Index Identification numbers have been assigned to in-line connectors, junction connectors, and terminals. The number is preceded by the letter ºC" for connectors "G" for ground terminals or "T" for non-ground terminals. * 1. With seat heater * 2: Without seat heater Connector to Harne

© 2016-2025 Copyright www.hcrv.net