Honda CR-V: Navigation System
Honda CR-V (2006–2011) Service Manual / Audio, Navigation,
and Telematics / Navigation System
Component Location Index
- GPS ANTENNA
- Removal/Installation
- NAVIGATION
MICROPHONE
(Inside the map light)
- Replacement
- NAVIGATION UNIT
- Removal/Installation
- REARVIEW CAMERA
- Removal/Installation
- VOICE CONTROL SWITCH
- Test
- Replacement
- PCM
- General Troubleshooting Information
- System Description
- Symptom Troubleshooting
- System Diagnostic Mode
- CD, DVD, and PC Card Removal/Installation
- Navigation Unit Removal/Installation
READ NEXT:
General Troubleshooting Information
General Operation
Refer to the navigation system manual, for the
navigation system operating procedures.
Anti-theft Feature
The navigation system has a coded theft protection
circuit. Make sure you ha
System Description
Overview
The navigation system is a highly sophisticated, hybrid locating system.
The navigation unit uses global positioning system (GPS) satellite signals,
internal yaw and vehicle speed inputs, a
Symptom Troubleshooting
No picture is displayed
NOTE: Always check the connectors for poor
connections or loose terminals between the audio unit,
audio disc changer, navigation unit, and XM receiver.
1. Check the No. 23 (10
SEE MORE:
General Troubleshooting Information
How to Check for DTCs with the Honda
Diagnostic System (HDS)
When the powertrain control module (PCM) senses an
abnormality in the input or output system, the D
indicator (A) in the gauge control module (tach) (B) will
usually blink.
When the Honda Diagnostic System (HDS) is connected
to the data l
Front Driveshaft Installation
1. Apply grease to the contact area (A) of the outboard
joint and front wheel bearing.
NOTE: Failure to apply grease may cause excessive
noise and vibration.
2. Install a new set ring (A) onto the set ring groove
(B) of the driveshaft (left driveshaft).
3. Apply 0.5-1.0 g (0.02-0.04 oz) of grease
© 2016-2026 Copyright www.hcrv.net
