Honda CR-V manuals

Honda CR-V: Transaxle

Honda CR-V (2006–2011) Service Manual / Transaxle

READ NEXT:

 Automatic Transmission

Special Tools 07HAE-PL50101 may also be used to substitute one of 07LAE-PX40100. Mainshaft Holder Attachment, 78 x 90 mm Clutch Spring Compressor Bolt Assembly Holder Handle Oil Seal Driver At

 General Troubleshooting Information

How to Check for DTCs with the Honda Diagnostic System (HDS) When the powertrain control module (PCM) senses an abnormality in the input or output system, the D indicator (A) in the gauge control modu

 System Description

SEE MORE:

 Front Driveshaft Installation

1. Apply grease to the contact area (A) of the outboard joint and front wheel bearing. NOTE: Failure to apply grease may cause excessive noise and vibration. 2. Install a new set ring (A) onto the set ring groove (B) of the driveshaft (left driveshaft). 3. Apply 0.5-1.0 g (0.02-0.04 oz) of grease

 Front Door

Front Door Panel Removal/Installation Special Tools Required KTC trim tool set SOJATP2014 * Trim pad remover, Snap-on A 177 A or equivalent, commercially available * Available through the American Honda Tool and Equipment Program; call 888-424-6857 NOTE: Use the appropriate tool from the KT

© 2016-2025 Copyright www.hcrv.net